Drawer Lock
Ref. #11-159

SOLD
Price: $9.00

NOTE: Sale of this item is not complete until you receive a  confirmation and shipping total from us.

 Drawer Lock is used  on a drawer .   It is mounted on the inside of a  drawer, facing (as pictured) to the outside. A hole is cut thru to match the keyhole and the hole center from the top edge is 1/2". It measures 1 1/8"  x  1 1/2" . This lock must be  mortised into the drawer (1" x 3/4" x 3/16"). It is keyed, restored and ready to be installed.

Drawer Lock
Ref. #11-161

1 Available
Price: $10.00

NOTE: Sale of this item is not complete until you receive a  confirmation and shipping total from us.

 Drawer Locks are used  on a drawer .   They are mounted on the inside of a  drawer, facing (as pictured) to the outside.   A hole is cut thru to match the keyhole and the hole center from the top edged is 1/2".  They  measure 1 1/4"  x  1 5/8" . These locks must be  mortised into the drawer (1 1/4" x 7/8" x 3/8"). The key handles may vary. They are keyed, restored and ready to be installed.

Early hand wrought iron grab lock or blanket chest lock.  Lock is mounted on the inside of blanket chests and when the lid is closed the lock automatically "grabs" the top keeper and locks the chest.  The key must be used to unlock and open the lid.  The top edge of this lock features decorative notching shown in close-up below.   Lock measures 6 1/4" high x 3 7/8" wide.  The key hole center from the top of lock is 4 1/4.  All of the parts are original, and is in original patina ready to be installed.

Cupboard or Drawer Lock
Ref. #11-67

2 Available
Price: $9.00 Each

NOTE: Sale of this item is not complete until you receive a  confirmation and shipping total from us

Cupboard or Drawer Locks are used on a Cupboard door  or on a drawer.   They are mounted on the inside of a cupboard or a drawer, facing (as pictured) to the outside,  a hole is cut to match the keyhole. The key hole center  is  5/8" from top of lock to the pin, 5/8" from right side to pin and 1" from left to pin.  It measures 2" from bolt edge to round edge x 1 3/4" wide. This lock must be installed in a dovetailed mortise (1 3/8" x 1 3/4" x 1/4"). The key handle may vary,  restored and ready to be installed.